Boulder Dash Forum

It's asking me JUMP: (HEX)?

What do I put here? I've completely forgotten >_<

I don't understand the (S)EI OR (C)LI question either. What's that?

EDIT: Another question I don't understand: "SHALL THE CRUNCHER SET 2D/2E?"

I don't remember this part from last time I crunched..

Sendy wrote:It's asking me JUMP: (HEX)?

What do I put here? I've completely forgotten >_<

Depends on the engine you are using. It should be stated on screen in the tool you're created your file with. And it should be mentioned in the manual for that tool also.

I don't understand the (S)EI OR (C)LI question either. What's that?

EDIT: Another question I don't understand: "SHALL THE CRUNCHER SET 2D/2E?"

Just choose anything.
The first is an assembler instruction added by the cruncher, but any BD engine sets it by itself, thus overriding the setting.
The latter is important for BASIC Kernel routines or code, which BD doesn't care for either.

Got it, thanks.